Skip to content

Worldwide shipping ◆ Orders ship within 3 working days

Home / Blog / Finger tape guides
13 Nov 2026 · Finger tape guides

How to Tape Your Fingers for BJJ: Step-by-Step Guide

Grappler wrapping finger tape around a finger before BJJ training

Finger tape is the cheapest piece of gear in a grappler's bag and one of the easiest to get wrong. Done well, a wrap keeps a sore joint supported, stops skin from tearing on gi fabric and gives you a little extra confidence when the grips get tough. Done badly, it unrolls in the first round or squeezes your finger until it goes numb.

This guide covers the basic single-finger wrap that works for almost every grappler, whether you train gi, no-gi or both.

What you need

  • A roll of rayon finger tape, ideally the 0.3 inch width for single fingers (our Lux Tape comes in exactly that size).
  • Clean, dry hands. Tape will not stick to sweat, lotion or hand sanitiser that has not dried.
  • Small scissors, or simply tear the tape by hand.

Step 1: Prep the finger

Wash and dry your hands. If you have a blister or cut, cover it with a small plaster first and tape over it. Trim your nails so a long nail does not snag the tape or the gi.

Step 2: Tear a strip about 20 cm long

A strip roughly the length of your hand is a good starting point for an average finger. Longer strips are harder to control. You can always add a second layer.

Step 3: Anchor on the section below the joint

Hold the finger slightly bent, the way it sits when you grip a sleeve. Start the tape on the underside of the finger, between the base and the middle joint, and wrap once around to lock it down.

Step 4: Wrap across the joint in a spiral

Spiral the tape upward, overlapping each turn by about half its width. Pull gently as you wrap so the layers sit flat. Do not stretch rayon tape hard; it is not meant to be elastic, and over-tensioning is the most common cause of numb fingertips.

Step 5: Finish and press

End the wrap on the finger section above or below the joint, never right in the crease of the joint. Press the end down and rub the tape with your thumb. The warmth helps the adhesive bond.

Check before you roll

  • Make a fist and open your hand five times. The tape should move with you.
  • Look at the fingertip. It should stay its normal colour.
  • Grip your gi sleeve. If the tape pinches, loosen it.

Common mistakes

Taping too tight. Support comes from the wrap staying in place, not from squeezing. Taping a straight finger. Wrap with a natural curl. Skipping the prep. Wet or oily skin is the number one reason tape comes loose. Re-using tape. Once it has soaked up sweat and been through a few rounds, replace it.

If you want a few different wrap styles to experiment with, read our guide on 3 ways to tape your fingers for BJJ, or see why taping matters in the first place in The Importance of Taping Your Finger.

This article is general training advice, not medical advice. If a finger is swollen, very painful or will not bend normally, stop training and see a doctor or physiotherapist.

Frequently asked questions

How tight should finger tape be for BJJ?

Snug enough that it stays put and supports the joint, but never so tight that the fingertip changes colour, tingles or throbs. If it does, cut it off and re-tape looser.

Should I tape over the joint or around it?

Most grapplers wrap across the middle of the finger joint with the finger slightly bent, so the tape does not restrict a natural grip. Tape applied on a fully straight finger tends to bunch or pull when you make a fist.

Tape up like you mean it.

Premium rayon finger tape for BJJ, climbing and more. Worldwide shipping, orders ship within 3 working days.

Shop finger tape →